Chrysler 2004 Concorde Service Manual page 95

LH
HALFSHAFT (Continued)
Fig. 6 Hub And Bearing To Stub Axle Retaining Nut
1 - HUB/BEARING ASSEMBLY
2 - NUT
Fig. 7 Inner Tripod Joint Removal from Stub Shaft
1 - TRANSMISSION STUB SHAFT
2 - INNER TRIPOD JOINT
3 - PRY BAR
4 - TRANSAXLE
(11) Remove driveshaft inner tripod joint from
transaxle stub shaft. When removing driveshaft,
do not pull on interconnecting shaft to remove
inner tripod joint from stub shaft. Removal in
this manner will separate the spider assembly
from the tripod joint housing. Grasp inner tri-
pod joint (Fig. 10) and interconnecting shaft
and pull on both pieces at the same time.
INSTALLATION
CAUTION: The inboard tripod joint retaining circlip
and O-ring seal (Fig. 11) on the transaxle stub shaft
are not re-usable. Whenever the inboard tripod joint
is removed from the stub shaft, the retaining circlip
Fig. 8 Strut Assembly To Steering Knuckle
Attaching Bolts
1 - STRUT ASSEMBLY
2 - NUTS
3 - STRUT ASSEMBLY TO STEERING KNUCKLE ATTACHING
BOLTS
4 - STEERING KNUCKLE
Fig. 9 Outer C/V Joint Removal From Hub and
1 - STRUT ASSEMBLY
2 - OUTER C/V JOINT
3 - HUB/BEARING ASSEMBLY
4 - FLINGER DISK
5 - STEERING KNUCKLE
and O-ring seal MUST BE REPLACED. The retaining
circlip and O-ring seal is included in all service kits
requiring removal of the inboard tripod joint from
the stub shaft.
HALFSHAFT 3 - 5
Bearing