Chrysler 2004 Concorde Service Manual page 262

8E - 16 ELECTRONIC CONTROL MODULES
SENTRY KEY IMMOBILIZER MODULE (Continued)
(3) Remove the steering column upper and lower
shrouds.
(4) Disengage the steering column wire harness
from the Sentry Key Immobilizer Module (SKIM).
(5) Remove the one screw securing the SKIM to
the bottom of the steering column.
(6) Slide the SKIM away from the steering column
to clear the SKIM antenna ring from around the
ignition switch lock cylinder housing (Fig. 11).
(7) Remove the SKIM from the vehicle.
INSTALLATION
NOTE: If the SKIM is replaced with a new unit, a
DRB III scan tool and the proper Body Diagnostic
Procedures Manual MUST be used to initialize the
new SKIM and to program at least two Sentry Key
transponders.
(1) Slide the SKIM toward the steering column
making sure the SKIM antenna ring is around the
ignition cylinder housing (Fig. 11).
(2) Install the one screw securing the SKIM to the
bottom of the steering column.
(3) Engage the steering column wire harness to
the Sentry Key Immobilizer Module (SKIM).
(4) Install the steering column upper and lower
shrouds.
(5) Install knee blocker.
(6) Connect the negative battery cable remote ter-
minal onto the remote battery post (Fig. 12).
LH