Chrysler 2004 Concorde Service Manual page 282

8F - 20 CHARGING
GENERATOR (Continued)
REMOVAL
REMOVAL - 2.7L
(1) Disconnect negative battery cable.
(2) Raise and support vehicle.
(3) Remove lower plastic splash shield (Fig. 1).
Fig. 1 GENERATOR 2.7L
(4) Remove transmission cooler and reposition
cooler out of the way.
(5) Remove lower radiator crossmember support
and position a jackstand under radiator for support.
(6) Loosen adjusting T-bolt, but do not remove.
(7) Loosen pivot bolt, but do not remove.
(8) Remove the generator drive belt. Refer to the
Cooling System section.
(9) Disconnect the generator field circuit plug.
(10) Remove the B+ terminal nut and wire.
(11) Remove pivot bolt, being careful not to lose
spacer.
(12) Remove generator.
REMOVAL - 3.5L
(1) Disconnect negative battery cable (Fig. 2).
Fig. 2 GENERATOR 3.2L/3.5L
(2) Loosen lower mounting bolt do not remove.
(3) Remove the upper radiator support and relo-
cate.
(4) Loosen the lower mounting bolt, but do not
remove
(5) Loosen pivot bolt, but do not remove.
(6) Loosen belt adjustment bolt.
(7) Remove the generator drive belt. Refer to the
Cooling System section.
(8) Remove lower mounting bolt.
(9) Disconnect the generator field circuit plug.
(10) Remove the B+ terminal nut and wire.
(11) Remove pivot bolt.
(12) Remove generator.
LH