Removal; Installation - Chrysler 2004 Concorde Service Manual

Hide thumbs Also See for 2004 Concorde:
Table of Contents

Advertisement

8N - 18
POWER SEATS
PASSENGER POWER SEAT SWITCH (Continued)
present, If OK go to Step 4 , If NOT OK repair the
open voltage supply circuit as required.
(4) Using an ohmmeter, perform the Seat Switch
Continuity Test table using (Fig. 6). If there is no
continuity at any of the switch positions, replace the
power seat switch.
Fig. 6 Seat Switch Pin Call-Out
PASSENGER SEAT SWITCH TEST
SWITCH
POSITION
OFF
FRONT RISER
UP
FRONT RISER
DOWN
CENTER
SWITCH
FORWARD
CENTER
SWITCH
REARWARD
REAR RISER UP
(IF EQUIP.)
REAR RISER
DOWN (IF
EQUIP.)
RECLINER UP
RECLINER
DOWN
CONTINUITY BETWEEN
PINS
PASSENGER
PIN 5 & 4
PIN 5 & 3
PIN 5 & 2
PIN 5 & 10
PIN 5 & 9
PIN 5 & 8
PIN 5 & 7
PIN 5 & 6
PIN 5 & 9
PIN 1 & 6
PIN 5 & 6
PIN 1 & 9
PIN 5 & 3
PIN 1 & 10
PIN 5 & 10
PIN 3 & 1
PIN 5 & 8
PIN 1 & 7
PIN 5 & 7
PIN 1 & 8
PIN 5 & 2
PIN 4 & 1
PIN 5 & 4
PIN 2 & 1

REMOVAL

(1) Open hood, disconnect and isolate the negative
battery cable remote terminal from the remote bat-
tery post.
WARNING: SOME VEHICLES ARE EQUIPPED WITH
SEATBACK
MOUNTED
ATTEMPTING TO DIAGNOSE OR SERVICE ANY
SEAT OR POWER SEAT SYSTEM COMPONENT
YOU MUST FIRST DISCONNECT AND ISOLATE THE
BATTERY NEGATIVE CABLE. THEN WAIT TWO MIN-
UTES FOR THE SYSTEM CAPACITOR TO DIS-
CHARGE BEFORE FURTHER SYSTEM SERVICE.
THIS IS THE ONLY SURE WAY TO DISABLE THE
AIRBAG SYSTEM. FAILURE TO DO SO COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY.
(2) Remove seat cushion side shield (Fig. 7). Refer
to the Body section for the procedure.
Fig. 7 Power Seat Switch and Seat Side Shield
(3) Disconnect wiring from switch.
(4) Remove knobs from the switch (Fig. 8).
(5) Remove switch attaching screws.
(6) Remove switch from cushion side shield

INSTALLATION

(1) Position the switch and install the switch
attaching screws.
(2) Install the knobs on the switch.
(3) Connect wiring electrical connector on switch.
(4) Install the seat cushion side shield. Refer to
the Body section for the procedure.
(5) Connect the negative battery cable remote ter-
minal on the remote battery post.
LH
AIRBAGS.
BEFORE

Advertisement

Table of Contents
loading

This manual is also suitable for:

300m

Table of Contents