Diagnosis And Testing - Windshield Washers - Chrysler 2004 Concorde Service Manual

LH
WIPERS/WASHERS (Continued)
Fig. 2 Body Control Module
1 - JUNCTION BLOCK/BCM
CONDITION
WASHER POWER FEED
FUSE OPEN.
BLOWN FUSE WHEN
WASHER SWITCH IS
DEPRESSED.
WINDSHIELD WASHER TEST
POSSIBLE CAUSE
1. JUNCTION BLOCK FUSE
#5 BLOWN.
1. SHORT IN WIPER/
WASHER SWITCH.
2. SHORT IN MOTOR
POWER CIRCUIT.
3. SHORT IN WASHER
MOTOR.
DIAGNOSIS AND TESTING - WINDSHIELD
WASHERS
Whenever a windshield washer malfunction occurs,
first verify that the windshield washer wire harness
is properly connected to all connectors before starting
normal diagnosis and repair procedures. Refer to
Windshield Washer Test table.
CORRECTION
1. CHECK FUSE #5. REPLACE IF NOT OK.
1. DEFECTIVE WASHER SWITCH. REFER TO
WIPE/WASHER SWITCH DIAGNOSTIC
PROCEDURES.
2. SHORT OR DEFECTIVE CIRCUIT BETWEEN
WIPER/WASHER SWITCH CONNECTOR
TERMINAL #2 AND MOTOR CONNECTOR
TERMINAL #1. IF NOT OK, REPAIR CIRCUIT.
3. CONNECT AN OHMMETER ACROSS
WASHER MOTOR TERMINALS #1 AND #2 AND
CHECK FOR A SHORT CIRCUIT. IF NOT OK,
REPLACE WASHER MOTOR.
WIPERS/WASHERS 8R - 3