Lamps/Lighting - Interior; Installation; Daytime Running Lamp Module Description; Operation - Chrysler 2004 Concorde Service Manual

8L - 10 LAMPS/LIGHTING - EXTERIOR
COMBINATION FLASHER (Continued)
(2) Remove the left instrument panel silencer.
Refer to Body, Instrument Panel Silencer, Removal.
(3) The flasher can be removed by pulling in a
rearward direction.

INSTALLATION

(1) Install the flasher by firmly pushing it into
place.
(2) Install the left instrument panel silencer. Refer
to Body, Instrument Panel Silencer, Installation.
(3) Connect the negative battery cable remote ter-
minal to the remote battery post (Fig. 9).
DAYTIME RUNNING LAMP
MODULE
DESCRIPTION
On vehicles equipped with Daytime Running
Lamps (DRL) (Canada only), they are controlled by
the Daytime Running Lamp Module. The DRL mod-
ule is attached to the Junction Block. The Junction
Block is located on the left side of the instrument
panel.

OPERATION

The DRL allows the high beam headlamps to illu-
minate at reduced power when the ignition switch is
in the RUN position with the high and low beam
headlamp switches in the OFF position. The Park
Brake must be released and the Brake Fluid Level
switch must be in the OPEN position to allow the
headlamps to operate in DRL mode. The daytime
running lamps will go out when the headlamp switch
is turned ON. The passing light feature will flash
bright high beams while the daytime running lamps
are activated.
DIAGNOSIS AND TESTING - DAYTIME
RUNNING LAMP MODULE
The Daytime Running Lamp Module (DRL Module)
is controlled by inputs received from the ignition
switch and High or Low Beam Headlamp relays,
Park Brake switch, and the Brake Fluid Level
switch. Refer to Wiring Diagrams, for component
location and circuit information and the proper Body
Diagnostic Procedures manual.
DECKLID/TRUNK LAMP

REMOVAL

(1) Open hood, disconnect and isolate the battery
negative cable.
(2) Remove lens from lamp from the rear shelf
(Fig. 10).
(3) Pull bulb from socket.
Fig. 10 Trunk Lamp Bulb
1 - BULB
2 - TRUNK LAMP SOCKET
3 - REAR SHELF
4 - LENS
INSTALLATION
(1) Insert bulb into socket.
(2) Install lamp lens.
(3) Connect the battery negative cable and close
hood.

FOG LAMP

DIAGNOSIS AND TESTING - FOG LAMP

When a vehicle experiences problems with the fog
lamp system, verify the condition of:
• Battery connections
• Charging system
• Fog lamp bulbs
• Headlamp switch
• Body Control Module
• Wire connectors
Refer to Wiring Diagrams, for component locations
and circuit information.
LH