Chrysler 2004 Concorde Service Manual page 230

8A - 4 AUDIO/VIDEO
AUDIO SYSTEM (Continued)
CONDITION
NO COMPACT DISC
OPERATION
AMPLIFIER
DESCRIPTION
MIDLINE AND INFINITY l SYSTEM
The amplifier is located in the right front cowl
panel.
INFINITY ll SYSTEM
The amplifier is located beneath the trunk liner
covering the right quarter inner panel.
OPERATION
For specific operation of each individual system,
refer to the vehicles owners manual, Audio System
Operation Manual.
When the radio system is ON, and all or some
speakers are not operating or have a noise distortion
refer to the diagnostic tests. Refer to the appropriate
wiring information. The wiring information includes
wiring diagrams, proper wire and connector repair
procedures, details of wire harness routing and
retention, connector pin-out information and location
views for the various wire harness connectors, splices
and grounds.
REMOVAL
MIDLINE/INFINITY l SYSTEM
(1) Disconnect and isolate the negative battery
cable.
(2) Remove right under panel silencer/duct.
(3) Remove mounting fastener to remote amplifier
(Fig. 1).
(4) Pull amplifier inboard and then pull downward
to remove from upper retaining clips.
(5) Disconnect two wiring connectors.
(6) Remove remote amplifier from vehicle.
INFINITY ll SYSTEM
(1) Disconnect and isolate the negative battery
cable.
(2) Inside trunk, pull the trunk liner aside (right
quarter panel passenger side).
POSSIBLE CAUSES
1. Faulty CD.
2. Foreign material on CD.
3. Condensation on CD or
optics.
4. Faulty CD player.
CORRECTION
1. Insert known good CD and test operation.
2. Clean CD and test operation.
3. Allow temperature of vehicle interior to stabilize
and test operation.
4. Refer to appropriate Diagnostic Service
Manual.
Fig. 1 Midline/Infinity Remote Amplifier Location
1 - HVAC UNIT
2 - REMOTE AMPLIFIER
3 - RECIRCULATION AIR MOTOR
(3) Remove three retaining screws (Fig. 2).
(4) Disconnect two wire connectors.
(5) Remove remote amplifier from vehicle.
INSTALLATION
MIDLINE/INFINITY l SYSTEM
(1) Install the remote amplifier into vehicle.
(2) Connect two wiring connectors.
(3) Push the amplifier upward and then outboard
to install into upper retaining clips.
(4) Install mounting fastener to remote amplifier.
(5) Install right under panel silencer/duct.
(6) Connect the negative battery cable.
INFINITY II SYSTEM
(1) Install remote amplifier into vehicle.
(2) Connect two wire connectors.
(3) Install three retaining screws.
(4) Install the trunk liner (right quarter panel pas-
senger side).
LH