Chrysler 2004 Concorde Service Manual page 242

8A - 16 AUDIO/VIDEO
SPEAKER (Continued)
(5) Pull speaker away from door and disconnect
wiring.
INSTRUMENT PANEL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove instrument panel top cover.
(3) Remove two retaining screws to center speaker
and disconnect wiring connector.
(4) Remove speaker from vehicle.
REAR DOOR
(1) Disconnect and isolate the battery negative
cable.
(2) Open rear door.
(3) Using a trim stick (special tool #C-4755), care-
fully pry speaker grille away from door trim panel
(Fig. 15).
Fig. 15 Rear Door Speaker
1 - DOOR SPEAKER
(4) Remove two speaker retaining screws.
(5) Pull speaker away from door and disconnect
wiring.
REAR SHELF
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the rear shelf trim panel. (Refer to 23 -
BODY/INTERIOR/REAR SHELF TRIM PANEL -
REMOVAL).
(3) Remove four retaining screws.
(4) Remove speaker and disconnect wire connector.
INSTALLATION
FRONT DOOR - LOWER
(1) Connect wiring and place speaker in door
speaker opening.
(2) Install three speaker retaining screws.
(3) Place speaker grille into place and firmly press
into place.
(4) Connect battery negative cable.
FRONT DOOR - UPPER
(1) Connect wiring and place speaker in door
speaker opening.
(2) Install two speaker retaining screws.
(3) Install two speaker
screws holding the enclosure ring and grill to the
door.
(4) Connect battery negative cable.
INSTRUMENT PANEL
(1) Place speaker into position on instrument
panel.
(2) connect wiring connector, install two retaining
screws to center speaker.
(3) Install instrument panel top cover.
(4) Connect battery negative cable.
REAR DOOR
(1) Connect wiring and place speaker in door
speaker opening.
(2) Install two speaker retaining screws.
(3) Place speaker grille into place and firmly snap
into place on the door trim panel.
(4) Connect battery negative cable.
REAR SHELF
(1) Connect wire connector and place speaker into
speaker opening.
CAUTION: Be sure that the wiring connectors are
facing forward when installed.
(2) Install the four retaining screws.
(3) Install the rear shelf trim panel.
(4) Connect battery negative cable.
LH
enclosure attachment