Operation; Removal; Installation; Side Repeater Lamp - Export Description - Chrysler 2004 Concorde Service Manual

8L - 38 LAMPS/LIGHTING - EXTERIOR
REAR FOG LAMP SWITCH - EXPORT (Continued)
Fig. 46 REAR FOG LAMP SWITCH

OPERATION

With the rotation of the rear fog lamp switch, volt-
age is sent through the rear fog lamp switch. This
illuminates the rear fog lamp or lamps. The head-
lamps must be "on" in order for the rear fog lamp/s to
function. Refer to the appropriate wiring information.
The wiring information includes wiring diagrams,
proper wire and connector repair procedures, details
of wire harness routing and retention, connector pin-
out information and location views for the various
wire harness connectors, splices and grounds.

REMOVAL

The rear fog lamp switch is integrated into the
headlamp switch on LH models. If the rear fog lamp
switch proves faulty the entire headlamp switch
must be replaced. (Refer to 8 - ELECTRICAL/
LAMPS/LIGHTING
SWITCH - REMOVAL).

INSTALLATION

The rear fog lamp switch is integrated into the
headlamp switch on LH models. If the rear fog lamp
switch proves faulty the entire headlamp switch
must be replaced. (Refer to 8 - ELECTRICAL/
LAMPS/LIGHTING
SWITCH - INSTALLATION).
- EXTERIOR/HEADLAMP
- EXTERIOR/HEADLAMP
SIDE REPEATER LAMP -
EXPORT
DESCRIPTION
Fig. 47 SIDE REPEATER LAMP
1 - SIDE REPEATER LAMP RETAINING TABS
2 - SIDE REPEATER LAMP HOUSING
3 - FENDER
One Side Repeater Lamp can be found on each side
of the vehicle just behind the front wheel (Fig. 47).
The side repeater lamp utilizes an amber colored
housing and clear bulb.
OPERATION
The side repeater lamps are turned ON or OFF
with the turn signal lamps. These lamps are con-
trolled by the steering column mounted multi-func-
tion switch.
DIAGNOSIS AND TESTING - SIDE REPEATER
LAMP - EXPORT
(1) Remove the suspect side repeater lamp bulb
and check for burned out condition. Replace bulb if
necessary.
(2) If the bulb appears to be OK, reinstall the bulb
in its socket and rotate the ignition switch to the ON
position. Turn the appropriate turn signal lamp ON
and check for lamp operation. If lamp is still inoper-
ative proceed to Step 3.
(3) Remove the suspect side repeater lamp bulb
and check for power (12v) and ground connections in
lamp socket. If either are not present, trace wire
until open or short is found.
REMOVAL
(1) Open front door.
LH