Troubleshooting; Printer Error Buttons - HID Fargo DTC1000Me User Manual

6

Troubleshooting

6.1

Printer Error Buttons

The DTC1250e and DTC4250e use button messages rather than a display message system.
All Printers have two (2) buttons:
ON/OFF
Pause
The display message system appears as a graphical message, for example:
Step Procedure
The ON/OFF (
1
Sleep mode, the button LED is dimmed but still ON.
The Pause (
2
and is not in an error state.
This button LED will continue to stay on while the printer prints as long as there is no error.
This button LED will also be dimmed when the printer goes into Sleep mode.
3 When an error occurs, the Pause (
4 Press the ON/OFF (
be cancelled.
Note: If no other error occurs, the Pause button illuminates as blue.
Press the Pause (
5
Note: The button illuminates as blue and retries the failed action.
When downloading an upgrade file, both buttons are blue and blink.
If a language (other than English) is currently selected, you can press and hold the Pause
6
( ) button during the power-up sequence to change the language back to English.
7 If no printer display is available, press or hold the buttons to access some internal tests.
To print a card with the Printer Settings, press the Pause (
seconds when the printer is ready and idle.
To print the Alignment or the Self Test, press and hold the Pause (
power-up sequence.
April 2014
DTC1000Me/DTC1250e/DTC4250e Card Printer User Guide, PLT-01668, Rev 1.1
) button is blue when the printer is ON. When the printer enters the
) button illuminates blue when the printer is capable of accepting a print job
) button when printer is in an error state to cause the action to
) button when printer is in an error state to cause the printer to retry.
) button no longer illuminates blue but blinks red.
) button and hold for 4+
) button during the
Page 69