HID Fargo DTC1000Me User Manual page 42

DTC1000Me/DTC1250e/DTC4250e Card Printer User Guide, PLT-01668, Rev 1.1
Setting
Write Heat Offset
Flipper Home Offset
Flipper Eject Height
Offset
Mag Super-Co Voltage
Offset
Mag Medium-Co Voltage
Offset
Head Home Offset
Head Print Offset
Head Contact Offset
Page 42
Adjust the Write temperature for the rewriteable cards as needed.
Increase the Current Setting to cause more heat to be used in
the printing process of a rewritable card.
OR
Decrease the Current Setting to cause less heat to be used in
the printing process of a rewritable card.
Note: Write Heat Offset provides user capability to control the
printhead heat level when the Write Operation is performed.
Appropriate heat levels should be applied for the proper writing
process.
This setting is a calibration driven value and should not be
adjusted. If the Flipper unit is replaced and has not been
calibrated this value may need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician.
This setting is a calibration driven value and should not be
adjusted. If the Flipper unit is replaced and has not been
calibrated this value may need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician.
This option changes the voltage going the magnetic head.
This setting is factory set and should not be changed unless
directed by a technician..
This option changes the voltage going the magnetic head.
This setting is factory set and should not be changed unless
directed by a technician.
This setting is a calibration driven value and should not be
adjusted. If the Printhead assembly is replaced then this value
may need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician
This setting is a calibration driven value and should not be
adjusted. If the printhead assembly is replaced then this value
may need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician.
This setting is a calibration driven value and should not be
adjusted. If the printhead assembly is replaced then this value
may need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician.
Description
April 2014