HID Fargo DTC1000Me User Manual page 74

DTC1000Me/DTC1250e/DTC4250e Card Printer User Guide, PLT-01668, Rev 1.1
Error Message
# 109
# 113
Ribbon Release
Error
# 110
Card Jam/Align
error
# 111
Head Loading
# 112
Card Jam/Align
error
# 128
# 170
Calibrate Ribbon
# 131
Flipper Jam/Home
Error
# 136
Secure Guard
Print Disabled
# 139
Please Remove
Ribbon
# 144
EEPROM Corrupt
EEPROM Read
Error
Page 74
Cause
The printer cannot locate the
next ribbon panel in order to
release the ribbon from the
card.
A card is jammed in the print
station or card flipping area of
the printer.
An unrecoverable error has
occurred during printing.
A card is jammed in the print
station or card flipping area of
the Printer.
The print ribbon sensor is out
of calibration or has failed.
A card has become jammed in
the printer's fipper table.
The flipper failed to position
properly while aligning a card
or flipping a card.
Printing is disabled by
SecureGuard until a password
is received.
Ribbon needs to be removed.
EEPROM restored with factory
default values.
Solution
Ensure that the ribbon is not stuck to
the card.
Replace the ribbon.
Recalibrate the ribbon sensor.
If the ribbon is broken, repair by taping
the ribbon back onto the take- up core
and manually advance to the next
panel.
Press the Pause button to continue.
Clear the jam. Press the Pause button
to continue.
Reset the printer and try again. If this
problem persists, call for technical
assistance.
Clear the jam. Press the Pause button
to continue.
Calibrate the ribbon sensor.
Check for material blocking sensor
and try again.
Clear any cards in the flipper table,
using the buttons to move the card
out.
Resume printing.
Reset the printer and retry. If problem
persists call for technical assistance.
Reset the printer and retry.
If the problem persists, call for
technical assistance.
Reset the printer and retry.
If problem persists, call for technical
assistance.
If changes were made in the
Advanced Setting tab in the printer
driver, click the Default button to reset
these numbers.
Reset the printer and try again. If this
problem persists, call for technical
assistance.
April 2014