HID Fargo DTC1000Me User Manual page 73

Error Message
# 82 Mag Jam
# 91
Ribbon Out
# 93
Wrong Ribbon
# 97
Ribbon Search
Error
# 99
Ribbon Error
# 100
Ribbon RFID Error
# 102
# 103
# 104
#3
Headlift Error
# 106
Job Data Error
# 107
Printing Error
April 2014
DTC1000Me/DTC1250e/DTC4250e Card Printer User Guide, PLT-01668, Rev 1.1
Cause
A card is jammed magnetic
station
The print ribbon has run out.
The print ribbon installed in the
printer does not match the
ribbon type selected in the
printer driver.
The ribbon is not able to find
the next panel correctly.
Check for jams/breaks.
The print ribbon has either
broken or jammed.
There is no ribbon or the ribbon
tag information is corrupted or
incorrect.
This is a problem with the
printhead Lift.
The print data sent to the
printer is corrupt or has been
interrupted.
An error was detected during
printing.
Solution
Clear any cards in the magnetic
station using the buttons to move the
card out.
Press the Pause button to continue.
Install a new ribbon.
Press the Pause button to continue or
the ON/OFF button to cancel.
Change either the installed print
ribbon or the ribbon type selected in
the printer driver.
Press the Pause button to continue or
the ON/OFF button to cancel.
Recalibrate the ribbon sensor.
If broken, repair by taping the ribbon
back on to the take- up core.
Replace the ribbon.
Press the Pause button to continue or
the ON/OFF button to cancel.
If jammed, clear the jam.
If broken, repair by taping the ribbon
back on to the take- up core.
Press the Pause button to continue or
the ON/OFF button to cancel.
Verify the printer driver settings for
correct Ribbon.
Try a new ribbon and continue.
Press the ON/OFF button to cancel.
Reset the printer and try again.
If this problem persists, call for
technical assistance.
Check the interface cable.
Select the ON/OFF button to cancel
this print job and then resend the job.
Reset the printer and try again.
If this problem persists, call for
technical assistance.
Page 73