Operation Procedure; Controls; Weight Defrosting - Bailey Approach Autograph Series Owner's Manual

Operation Procedure

1. Plug power supply cord into 230V AC 50Hz
power outlet.
2. Press Eco button until beep sounds and
display is turned on.
3. After placing the food in a suitable
container, open the oven door and put it
on the glass tray. The glass tray and roller
guide must always be in place during
cooking.
4. Close the door
5. The oven door can be opened at any time
during operation by pushing the door open
button. The oven will automatically shut
off.
6. The oven automatically cooks on full power
unless set to a lower power level.
7. The display will show " : 0" when the oven
is plugged in, press and hold Eco button
until display is turned on and beep sounds.
8. Display will be returned to the " : 0 " when
the cooking time ends.
9. When the STOP/CLEAR button is pushed
during the oven operation, the oven stops
cooking and all information retained. To
erase all information, push the STOP/
CLEAR button once more. If the oven door
is opened during the oven operation, all
information is retained.
10. If the START button is pushed and the oven
does not operate, check the area between
the door and door seal for obstructions and
make sure the door is closed securely. The
oven will not start cooking until the door is
completely closed or the program has been
reset.
11. Display turns off after 10 minutes.
WARNING: Make sure the oven is
properly installed and plugged into
the electrical outlet:

Controls

Turning AC power ON & OFF the oven.
When the oven is first plugged in, the display
will show nothing.
1. Press and hold the Eco button until display
is turned on and the beep sounds. The oven
is turned to AC power on.
2. Press and hold the STOP/CLEAR button
until display is turned off. The oven is
turned off and will use no power.
NOTE: If the mains power goes off,
the display disappears until the
power comes back on and the Eco
button is pressed and held until a
beep sounds.
The oven is automatically powered off if not
used for 10 Minutes.

Weight Defrosting

When WEIGHT DEFROST is selected, the
automatic cycle divides the defrosting time into
periods of alternating defrost and stand times
by cycling on and off.
1. Push the WEIGHT DEFROST button - the
display will show you "0".
2. Push the TIME SET buttons for inputting
the desired weights - the display will show
you what you selected.
3. Push the START button.
NOTE: Your oven can be programmed
for 200g~3000g
defrosting mode.
The defrosting time is automatically determined
by the weight input. When you push the START
button, the display counts down the time to
show you how much defrosting time is left.
The oven beeps during the defrosting cycle to
signal that the food needs to be turned over or
rearranged. When the defrosting ends, you will
hear 3 beeps.
117
in Weight