Refi T And Check Window - Valor Madrona MF28JLN NG Installation & Owner's Manual

QUALIFIED
INSTALLER
4. Place the front right log on the burner and slide it to
the left against the front left log.
5. Locate the top right log on the two pins on the right
side of the rear log. Ensure a tight fi t against the fl at
area around the pins in the rear log.
Refi t and Check Window
To refi t the window:
1. Place it on the fi rebox frame and hold it in place
while pushing and turning its fastening studs 90
degrees.
IMPORTANT: To ensure a safe operation, verify
that the bolts are hooked properly to the window
tabs; then, pull out the top of the window and
release it to insure the springs return it.
2. Then, apply light hand pressure against the window
frame sides to bed-in the window seal.
3. If the Hot Glass Warning plate has been
removed from the front lower corner of the
window, reinstall it by sliding it between the
glass and the frame as indicated.
32 32
Installation
6. Place the lower end of the center right log onto the
pin on the front right log. Rest the narrow end in the
notch into the rear log.
Notch in rear log
x 4
Hot Glass Warning Plate
Pin in
front right
log