Table of Contents
Advertisement
OWNER'S
INFORMATION
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.
Using Handset Wall Holder
Your fi replace equipment includes a wall
holder to store the handset. If it hasn't be
installed, refer to the instructions further
on in this manual for the installation.
Replacing Batteries
WARNING
!
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the fi replace cool fi rst before touching it.
CAUTION
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the battery box
or the handset! This could cause a short circuit.
Low battery signal: see page 14.
BEFORE changing the batteries, turn off the valve
using the switch's On/Off button.
The appliance uses four 1.5 V AA alkaline batteries
for its remote control receiver and one 9 V alkaline
battery for its handset. Batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off-season will extend the battery life. Should
the batteries lose power, the control may be operated
by manually turning the control knob at the valve or by
turning off the valve at the switch.
To replace the batteries in the remote control
receiver:
1. The receiver is located to the left of the valve and
it is clipped to the casting's cross beam. Unclip the
receiver from the cross beam.
2. Slide and remove the receiver cover.
3. Replace the batteries with 4 AA alkaline batteries.
4. Replace the cover.
5. Clip the receiver back to the cross beam.
Touching Up Paint
If you need to touch up the paint on your matte cast
unit MFCS01, use the Stove Bright by Forrest 1990
Satin Black spray paint. Please note that it may be
necessary to spray the entire cast piece.
8 8
Owner's Information
Locating Lighting, Operation and Rating
Information Plate
DO NOT ATTEMPT TO TOUCH THE DATA PLATE
WHILE THE STOVE IS STILL HOT! Let the stove
cool fi rst before touching it.
The Lighting, Operation and Rating Information Plate
is located on the rear of the appliance casing.
To access the plate, reach over the top of the stove
and pull the plate out from its holder to read it. There is
important information on both sides of the plate.
Servicing Your Stove
If any attention is required for your appliance, contact
your supplier quoting the model number. It will be
helpful if the appliance serial number can also be
quoted. This number is on the rating plate, which is
attached to the unit. The replacement parts are shown
at the end of this manual. Please always quote the part
number and description when requesting spare parts.
Operating Your Stove
There are three ways to control your fi replace.
1. Thermostatic Remote Control;
2. Wall Switch;
3. Manual On/Off Switch.
The manual On/Off switch must be ON for the fi replace
to function. It can be used to shut off the fi replace in
case of emergency—see above.
The Thermostatic Remote Control can be programmed
to function automatically—see pages 10–14.
The Wall Switch (optional) can be used to turn on, off
and to increase or decrease the fl ame height—see
1265WSK—Wall Switch Kit.
NOTE: The remote control in the AUTO mode will
override the wall switch.
Thermostatic Remote
WARNING
!
Wall Switch
Control
(optional)
ON
OFF
Manual On/Off Switch
Hide quick links:
Advertisement
Table of Contents
