Checking Pilot And Burner Flames - Valor Madrona MF28JLN NG Installation & Owner's Manual

Dv gas fireplace heater (engine only)

Hide thumbs

Table Of Contents

Table of Contents

To reﬁ t the window:

1. Place it on its frame and hold it in place while

pushing and turning its fastening studs 90 degrees.

IMPORTANT: To ensure a safe operation, verify

that the bolts are hooked properly to the window

tabs; then, pull out the top of the window and

release it to insure the springs return it.

Then, apply light hand pressure against the window

frame sides to bed-in the window seal.

2. If the Hot Glass Warning plate has been removed

from the front lower corner of the window,

reinstall it by sliding it between the glass and

the frame as indicated.

Hot Glass Warning Plate

3. Traditional stove MFCS01 and MFCS02: Re-hook

the cast front.

Contemporary stove MFCS04:

a) Re-install the upper side columns on each side

of the window ﬁ tting the bottom ﬁ rst and then

pushing in squarely sliding the spring clips on the

inside edge of the side panels.

b) Re-insert the concrete cast shelf between the

upper and lower columns. Close the access door

if opened.

c) Re-hook the window frame cover to the window's

spring-loaded top bolts.

4. Traditional stove MFCS01 and MFCS02: Re-install

the barrier screen by inserting ﬁ rst the top clip in the

arch of the front and then pushing on the side of the

screen so that the clips snap into place.

Contemporary stove MFCS04: Re-install the

barrier screen by hooking ﬁ rst the lower brackets

to the inside edge of the concrete shelf and then

pushing the screen against the stove so the upper

clips snap on the upper side columns.

Cleaning the Stove Casing

WARNING

DO NOT TOUCH THE STOVE WHILE IT IS

HOT! Let the stove cool first before cleaning it.

Owner's Information

Barrier screens

FOR SAFETY PURPOSE, ensure the barrier

screen is re-installed on the stove front after

maintenance.

The barrier screens can be brushed clean.

Cast iron stove body

The matte cast iron stove body can be brushed clean.

The enameled cast iron stove body can be cleaned with

mild soap and water then dried with a lint-free soft cloth.

Cast concrete stove body

Dust down the surface regularly with a soft brush and

occasionally follow up with a wipe over with a wet cloth.

A sealer has been applied to the concrete surface, no

cleaning agents nor polishes should be used. In case

of an accidental spill, soak up the liquid IMMEDIATELY

with a dry cloth and follow up with a wipe down with a

wet cloth.

Logs and burner

Dust can be brushed from the ceramic logs and ﬁ rebox

walls after removing the front unit and opening the win-

dow. Dust can also be removed from the burner using

a soft brush after removing the ceramic logs. When

cleaning, make sure that no particles are brushed into

the slots of the burner.