Install Ceramic Logs - Valor Madrona MF28JLN NG Installation & Owner's Manual

Install Ceramic Logs

Unpack the ceramic logs very carefully to avoid damaging their fragile material. Install the logs as shown below.
Please note that the position of the logs is critical to insure the good performance of the appliance.
1. Place the rear log on the sheet metal support. Pull
it forward until the notch in the underside of the
log sits against the front edge of the sheet metal
support. Slide the log towards the left hand side until
the notch in the log touches the right angled return
edge of the pilot shield as indicated.
Rear log pushed to
the left abuts the
pilot shield
2. Place the front left log on the burner. Slide it towards
the left until its narrow end rests in the notch of the
rear log as indicated.
Installation
3. Place the top left log on the pin of the rear log. The
bottom of the log rests on the left side end of the
front left log just installed.
Note: Make sure the lower end of the top log rests
on the front log as indicated and does not fall below
in the fi rebox.
This log must
rest ON the
front log
Pilot area
Front log
QUALIFIED
INSTALLER
31 31