TRENDnet TV-IP342PI User Manual page 35

TRENDnet User's Guide
Event Configuration >> GPIO Setting >> Output Setting

Mode Setting
On/Off Switch:
When event occurs, the camera triggers the external devise and lasts for
certain of time according to the event "interval" setting. If it's triggered by
motion detection, the triggering time is according to "interval" setting of
motion detection. If it's triggered by external input alarm, the triggering
time is according to input "interval" setting. It triggers the external devise
and lasts for 10 seconds if you select "10" in interval setting. You can turn
off the alarm manually by click "off" at the bottom-right of the live screen
page.
Time Switch:
When event occurs, the camera triggers the external devise and lasts for
certain of time according to the output "interval" setting, and the user is
not allowed to break off the alarm manually.
3. Output Test
After the external output hardware is installed, you can use the "Relay Out" button
on the live video page to test if DO device works.

On/Off Switch mode:
Click "ON", the camera will trigger the external output devise. For example,
your alarm buzzer will continuously ring. You can manually break off the output
signal by clicking "OFF".

Time Switch mode:
Click "Pulse", the camera will trigger the external output devise for several
seconds. The duration length is according to the "interval" setting in Output
Setting.
© Copyright 2014 TRENDnet. All Rights Reserved.
Event Configuration >> Logs
Click "Logs" to see System Logs, Motion Detection Logs, GPIO Logs and All Logs. If you
remove the power from IP camera, Motion Detection Logs will be cleared away.
TV-IP342PI
34