TRENDnet TV-IP342PI User Manual page 21

TRENDnet User's Guide
Network >> Advanced >> IP Address Filter
deny an IP address or even a range of the IP address to access the IP camera. If you
would like to deny a range of IP address but would allow an IP within that range can
access the camera, please setup the allow IP address in the 1
nd
range of IP address as 2 priority as example below.
© Copyright 2014 TRENDnet. All Rights Reserved.
Network >> Advanced >> QoS/DSCP
DSCP specifies a simple mechanism for classifying and managing network traffic and
provide QoS on IP networks. DSCP is a 6-bit in the IP header for packet classification
purpose.
The number 0~63 for Live Stream, Event / Alarm, and Management represent the ratio
that the bandwidth is divided. For example, if you set 5, 10, and 20 for these three
items, then the bandwidth of these items is 5:10:20. The item getting more bandwidth
has lower probability to be delayed. There is no difference between setting "0, 0, 0" or
"63, 63, 63" because under these two setting the three items will get equal bandwidth
You can allow or
(1/3).
The three stream control the protocols respectively:


st
priority and set the deny

Note: The "Management" stream handles both the live view and the setting area of the
web page on which the data is transferred via http/https protocol. If you prefer to
distribute more bandwidth when using the web browser to watch the live video, please
adjust the Management Stream instead of Live Stream.
Live Stream (Video and audio) : RTP / RTSP
Event/Alarm : FTP / SMTP / SAMBA / SIP
Management : HTTPS / HTTP / SNMP
TV-IP342PI
20