TRENDnet TV-IP342PI User Manual page 34

TRENDnet User's Guide
1. I/O Connection

Please connect the GND & DO pin to the external relay (buzzer) device.
When no event occurs, DO output is 5V (DO and GND are disconnected). When
the camera detects event happening and triggers external alarm, DO output is
0V (DO and GND are connected).

Please connect the GND & DI pin to the external trigger device.
If you select "N.O" in "Input sensor setting", when external devise or circuit
makes DI and GND pin connected, the camera input alarm is triggered, and
then camera will execute the action user has set, for example, send snapshot to
E-mail address.
If you select "N.C" in "Input sensor setting", when external devise or circuit
makes DI and GND pin disconnected, the camera input alarm is triggered, and
then camera will execute the action user has set, for example, send snapshot to
E-mail address.
© Copyright 2014 TRENDnet. All Rights Reserved.
GPIO PIN definition
GND (Ground): Initial state is LOW
DO (Digital Output): DC 5V
DI (Digital Input): Max. 50mA, DC 5V
2. GPIO Setting
Event Configuration >> GPIO Setting >> Input Setting

Input Sensor: According to your external device and circuit design, select N.O
(normally open) or N.C (normally closed).

Input Action: When the camera input alarm is triggered, it can trigger the relay
out, or send the video to E-mail/ FTP/ SAMBA.

Interval: If you select "10 sec" here, once the input alarm is detected and
action is triggered, it cannot be triggered again within 10 seconds.

Based on the schedule: When click the option box, only during the selected
schedule time the I/O is enabled. That is, for example, the 11th hour of Monday
has not been colored in the schedule table, then no action will be triggered
even the camera detects input signal during 11:00~12:00 on Monday.
TV-IP342PI
33