TRENDnet TV-IP342PI User Manual page 31

TRENDnet User's Guide
Event Configuration >> Motion Detection

Area Setting: Click Area 1 /Area 2/Area 3 icon then draw the motion detection area
on the live screen. If there is any motion detected in these areas, the "Motion!"
wording will show on the live screen. To clean the motion detection area, click Area
1 /Area 2/Area 3 icon again.

Sensitivity: Select motion detection sensitivity from 1 to 10.

Trigger Action (Area 1, Area 2, Area 3): When motion is detected, the camera can
send video or snapshot to Email, FTP, Output device and Samba.
Note: Due to network/Internet bandwidth constraint, the IP camera may not
transfer video to selected destinations simultaneously. Keep the number of
destinations as few as possible to avoid possible data loss.

Subject: This subject will appear as the subject when sending the motion detected
video or snapshot to email.
© Copyright 2014 TRENDnet. All Rights Reserved.

Interval: Each motion triggered in defined interval time. If you select "10 sec" here,
once the motion is detected and action is triggered, the next motion will be trigger
after 10 seconds. .

Based on the schedule: The motion detection will be triggered based on the
schedule you define.
Event Configuration >> Motion Detection >> Tampering Detection

Tampering: Enable / Disable Tampering. When enabled and tampering is detected,
the camera will send video or snapshot to Email, FTP, Output device or Samba.
Event Configuration >> Motion Detection >> Record File
When an event occurs, the IP camera can record a video clip or take snapshot, and then
send the file to mail/ FTP/ Samba. Select what format you want to save.

AVI File (with Record Time Setting): Save AVI video file. The video length is
according to the value you set in Record Time Setting.

JPEG File (Single File with Interval Setting): Save single JPEG picture file when event
occurs.

JPEG Files (with Record Time Setting): Only when you select "JPEG" in streaming 1
video format of Video Setting, this option can be enabled. Select this option to save
several JPEG picture files, and the successive picture files cover a period of time
according to the value you set in Record Time Setting.
TV-IP342PI
30