TRENDnet TV-IP342PI User Manual page 18

TRENDnet User's Guide
Safari browser does not support https protocol. If you selected "https" mode, you will
see the camera appears on Safari's bookmarks but will not be able to access the camera.
Network >> Network Setting >> LLTD
If your PC supports LLTD, enable this function then you can check the connection status,
properties, and device position(like IP address) of this IP Camera in the network map. In
Windows Vista or Windows 7, you can find LLTD through the path: Call out the Control
Panel → Network and Internet → Network and Sharing Center → Click "See full map".
Network >> Advanced >> HTTPS
When the users access cameras via Https protocol, the transmitted information will be
encrypted so that the security level is arisen.
You can select the connection type.

Http: user can access the camera via Http path.

Https: user can access the camera via Https path but cannot via Http path.

Http & Https: Both the Http and Https path can be used to access the camera.
When you change the setting of connection type, it may cause connection error or
disconnection error if you switch the protocol directly. Therefore, Http & Https
mode is necessary. If you want to change from Http to Https, please switch to "Http
& Https" mode first, and then switch to "Https" mode. Same method when you
change from Https to Http.
The Https protocol has certificate verifying mechanism. When the user access a website
via Https, the browser will check the certificate of that domain and verify its trustiness
and secure.
Certificate generation process:
© Copyright 2014 TRENDnet. All Rights Reserved.
1. Remove the existing certificate: Before you generate a new certificate, please
remove existing one. Select "Http" connection type and click "Remove". If a dialog
box pops up to ask you to confirm, click "Yes".
2. Created Request: Fill in the following form and click "apply".
TV-IP342PI
17