Debug Display - Cisco 7960G Administration Manual

Device Logs

Debug Display

Cisco IP Phone Administration Guide for Cisco CallManager 4.0, Cisco IP Phones 7960G/7940G
7-16
The Debug Display area on a phone's web page displays a log of up to the 50 most
recent alarms for the phone. Alarms indicate a variety of errors or conditions.
To display the Debug Display area, access the web page for the phone as described
in the "Accessing the Web Page for a Phone" section on page
the Debug Display hyperlink.
Table 7-5 explains the alarm message that can appear in the Debug Display area.
Table 7-5 Alarm Message Numbers and Explanations
Alarm Number Explanation
1 Configuration file that the phone tried to obtain from the
TFTP server was too large (greater than 2 MB)
3 Firmware image that the phone tried to obtain has and
incorrect name
4 Phone's Flash memory is full
6 Configuration file that the phone requested does not exist on
the TFTP server
7 A request to the TFTP server timed out
8 Phone Could not log on to the TFTP server
9 General TFTP error
14 Cisco CallManager closed socket
15 Phone lost connection to the remote host
16 Cisco CallManager indicates that the phone could not
unregister for some reason
17 Cisco CallManager stopped responding to KeepAlive
requests
18 Phone failed back to a higher priority Cisco CallManager
20 User pressed **#** on the phone
21 Phone obtained a new IP address
22 Cisco CallManager sent a reset instruction to the phone
23 Cisco CallManager sent a restart instruction to the phone
Chapter 7 Monitoring the Cisco IP Phone Remotely
7-2, and then click
OL-4825-01