Xineron FASTRAX III Instruction Manual page 35

PRESET FOCUS DEFAULT
This menu set the default mode of the focus when you save the preset.
FOCUS
• ORIGIN OFFSET
This feature is useful to align a new dome camera exactly the same as the previously installed dome
camera.
Dome camera's origin set and all data initialize option do not override offset values. Only the default set
option in this menu will set the offset value to zero. This can be used to avoid ceiling obstructions.
• DOME RESET
This feature is used to re-calibrate the orientation of a selected dome camera. Origin offset value is not
affected by this function. (Offset is still valid after origin set)
• SYSTEM MENU
PRESET FOCUS DEFAULT
FOCUS
SAVE AND EXIT(ESC TO CANCEL)
: AUTO/MANUAL/ONE PUSH
OFFSET SETUP
PAN OFFSET
TILT OFFSET
ENABLE
SAVE AND EXIT(ESC TO CANCEL)
ARE YOU SURE ?
SYSTEM MENU
MOTOR SETUP
PASSWORD EDIT
ORIGIN CHECK
WHITE DEFECT COMPENSATION
CALIBRATION
PASSWORD ENABLE
MENU TIME OUT
BLINK CURSOR
DOME ANSWER
SAVE AND EXIT(ESC TO CANCEL)
: AUTO
(CTRL KEY)
: 000.0
: 000.0
: OFF
DOME RESET
CANCEL
OK
: ON
: OFF
: OFF
: ON
: ON