Shortcut Of Preset Program - Xineron FASTRAX III Instruction Manual

Network dome camera
Table of Contents

Advertisement

Set SENSITIVITY: 1~10(22X model) / 1~15(36X model)
Set POSITION: ALL, CENTER
Set DELAY: 0~5 SEC
Set OUTPUT: OFF, OUT1
Set HOLD TIME: 3~99 SEC
Select "AE SETUP" and pushing the Joystick left or right. Then the AE setup displays. Refer to the AE
SETUP in the camera setup.
6. Set "DWELL TIME"(03-99second)
7. To select the next page of presets, scroll the page by pushing the Joystick to the Left
on the first and last columns of the menu.
8. Repeat steps 2 through 7 for each additional preset position.
9. Select Save and Exit by pushing the Joystick to the right. Press ESC to exit the Preset menu without
saving.
NOTE: Press the HOME key at programmed preset position(*) to delete a programmed preset view.
The position, which is marked with * , already has the preset view assigned. To review the stored preset,
press PRST key on the *, The camera will show the stored preset scene.
Hold down the CTRL key while selecting the desired scene using the Joystick . Current position will be
displayed. Release CTRL key to complete. Or Press IRIS Open then the "CTRL" displays. Move the
desired position and the zoom position. Press IRIS Close then the "CTRL" disappears. Select Exit and
push the Joystick to the right.

3.6 Shortcut of Preset Program

After selecting the desired scene, press No. ( 1 to 240 ), and press CTRL and PRST subsequently. The
current view will be stored to the selected preset number if the preset number is empty. If selected preset
number is not empty, " OVER WRITE " message will be displayed on the monitor and select the "OK" and
push the Joystick to the right to overwrite.
Example : 1 , 0 , 1 + CTRL + PRST will store current view as preset No. 101 . In this case, focus will be
programmed as Auto, dwell time will be set to 3 second, and the current AE mode will be programmed.
MOTION SETUP
SENSITIVITY : 12
POSITION
: ALL
DELAY
: 00 SEC
OUTPUT
: OFF
HOLD TIME
: 03 SEC
EXIT(ESC TO EXIT)
PRESET AREA SETUP
NUMBER 001
PAN
TILT
000.0
000.0
EXIT(ESC TO EXIT)
(CTRL KEY)

Advertisement

Table of Contents
loading

Table of Contents