Xineron FASTRAX III Instruction Manual page 18

6. Select "START ANGLE". Hold down the CTRL key while selecting the start position using the Joystick .
Current panning position will be displayed. Release CTRL key to complete the selection of the start
position. Or Press IRIS Open then the "CTRL" displays. Move the desired position and the zoom
position. Press IRIS Close then the "CTRL" disappears. To adjust at the 0.1 degree interval, twist the
Joystick at the pan field and the tilt field. To adjust at the one zoom interval, twist the Joystick at the
zoom field.
7. Select "END ANGLE." Hold down the CTRL key while moving the Joystick to select the end position.
The end position angle should be larger than start position. Release the CTRL key to complete the
selection of the end position. Or Press IRIS Open then the "CTRL" displays. Move the desired position
and the zoom position. Press IRIS Close then the "CTRL" disappears. To adjust at the 0.1 degree
interval, twist the Joystick at the pan field and the tilt field. To adjust at the one zoom interval, twist the
Joystick at the zoom field.
8. Set "SCAN DIR" to CCW or CW.
9. Select "SWAP". Set to ON, to exchange the start angle and the end angle.
10. Set "DWELL TIME".
11. Select Save and Exit and push the Joystick to the right or press IRIS Open . Press ESC or IRIS
Close to exit the program without saving.
Pressing the HOME key delete stored data at the angle field.
To set the position using the preset position:
a. Before entering the Auto Scan menu, select a preset position as a starting point for
Auto Scan.
Example: 2 + PRST and do step 1 to 4. In step 5, just press the Ctrl key at the start angle position, the
current position will be displayed as a start position.
b. Save and exit from the menu.
c. In normal mode, call a preset to be the end point of scan. Press 3 + PRST then press Scan key to
enter the Auto Scan menu. Move the cursor position to END ANGLE. Just press CTRL key at the end
angle position. Save and exit from the menu.
Press SCAN key on the angle field to display with the small OSD. Then the screen will show as below.
The setting procedure is the same as above.
NOTE: 09:AUTO-PAN mode(Endless panning)
AUTO SCAN AREA SETUP
NUMBER01
START: ----- ----- ---
END : ----- ----- ---
EXIT(ESC TO EXIT)
(CTRL KEY)