Area Title - Xineron FASTRAX III Instruction Manual

Press PTRN key on the title field to display with the small OSD. Then the screen will show
as below.
The setting procedure is the same as above.

3.9 Area Title

Enter a specific name on programmed angle between START and END. For the screen below, when the
camera points at an angle between 124.3 ° (PAN), 30.7 ° (TILT) to 359.5 ° (PAN), 45.4 ° (TILT), ABC will
be displayed on the screen.
:01 - 16
NUMBER
:up to 12 characters.
TITLE
: Swap the start point for the end point.
SWAP
1 . Select the" NUMBER" and set the desired number by pushing the Joystick left or right.
2. To edit the title, follow the procedure of the auto scan above to edit titles.
3. Select "START ANGLE". Hold down the CTRL key while selecting the start position using the Joystick .
Current panning position will be displayed. Release CTRL key to complete the selection of the start
position. Or Press IRIS Open then the "CTRL" displays. Move the desired position. Press IRIS Close
then the "CTRL" disappears. To adjust at the 0.1 degree interval, twist the Joystick at the pan field and
the tilt field.
4. Select "END ANGLE." Hold down the CTRL key while moving the Joystick to select the end position.
Release the CTRL key to complete the selection of the end position.
Or Press IRIS Open then the "CTRL" displays. Move the desired position. Press IRIS Close then the
"CTRL" disappears. To adjust at the 0.1 degree interval, twist the Joystick at the pan field and the tilt
field.
5. Select "SWAP". Set to ON, to exchange the start angle and the end angle.
6. Select Save and Exit and push the Joystick to the right or press IRIS Open . Press ESC or IRIS
Close to exit the program without saving.
PATTERN AREA SETUP
NUMBER 01
000 00.0%
0001 01.0%
EXIT(ESC TO EXIT)
AREA TITLE SETUP
NUMBER : 01
TITLE : ABC
START ANGLE : 124.3
END ANGLE : 359.5
SWAP : OFF
SAVE AND EXIT(ESC TO CANCEL)
(CTRL KEY)
30.7
45.4