Auto Scan - Xineron FASTRAX III Instruction Manual

3.4 Auto Scan

The Auto scan supports up to 17 programmed angles at user-programmable speeds. Follow these steps
to program Auto Scan:
:01 -08, 10-17, 09 :AUTO PAN mode
NUMBER
:up to 12 characters.
TITLE
:NORMAL, VECTOR, RANDOM (AUTO PAN mode :NORMAL, RANDOM only)
MODE
NORMAL: Move from start point to end point in panning only.
VECTOR: Move from start point to end point including tilt and zoom simultaneously and
linearly. In some model, the zoom is fixed at wider angle and the zoom magnification
information is not displayed.
RANDOM: Move randomly between the start point and the end point.
: 1 - 13 step, the lower number means the slower speed.
SPEED
: Set the scan direction, CCW(Counter Clock Wise), CW(Clock Wise)
SCAN DIR
: Swap the start point for the end point.
SWAP
: Set the dwell time at the both end, 01 – 99 seconds
DWELL
1. Press the SCAN key to enter the auto scan menu directly. Or press the MENU key to display the main
menu on the monitor. Scroll to Auto Scan and push the Joystick to the right.
2. Select the" NUMBER" and set the desired number by pushing the Joystick left or right.
3. Select the "TITLE" and twist the Joystick to enter the title edit mode.
4. Twist the Joystick by changing the alphanumeric characters and move the next position. Or move
down to the character table and press CTRL or IRIS OPEN at the desired character then the cursor
position moves to the next position automatically. Push the Joystick left or right at the "ALL DELETE"
field to delete all characters. Push the Joystick left or right at the "EXIT" field to finish title edit menu.
5. Select "MODE" and "SPEED".
(Shortcut: SCAN )
AUTO SCAN SETUP
NUMBER
TITLE
MODE
SPEED
START ANGLE : ----- ----- ---
END ANGLE
SCAN DIR
SWAP
DWELL
SAVE AND EXIT(ESC TO CANCEL)
TITLE EDIT MENU
A01
*
A B C D E F G H I J
K L M N O P Q R S T
U V W X Y Z 0 1 2 3
4 5 6 7 8 9 ( )
ALL DELETE
EXIT (ESC TO EXIT)
: 01
: A01
: NORMAL
: 5 STEP
: ----- ----- ---
: CCW
: OFF
: 03 SEC