Working With The Food Processor - Silvercrest SKM 550 A1 Operating Instructions Manual

• Move the swivel arm
operating position 1 (see chapter "Operating
positions") and let it engage, so that the lid is
firmly seated.
• Set the rotary switch
Risk of injury from rotating parts!
NEVER reach into the mixing bowl
Only change accessories when the drive motor
is at standstill! After being switched off, the drive motor
continues to run for a short time. The appliance
j
may only be used when the drive openings not
being utilised are covered with drive protection lids.
In cases of malfunction switch the appliance off and
remove the plug from the wall socket, this will avoid
an unintentional switching-on of the appliance.
Refilling with ingredients
• Turn the appliance off with the rotary switch
• Turn the rotary switch
until the drive motor
(Fig. ).
• Press the unlocking button
the swivel arm a little.
h
• Remove the lid.
• Press the unlocking button
the swivel arm h into operating position 5 (see
chapter "Operating positions").
• Fill with ingredients.
On task completion
• Turn the appliance off with the rotary switch
• Turn the rotary switch
until the drive motor
(Fig. ).
• Press the unlocking button
the swivel arm a little.
h
• Remove the lid.
• Press the unlocking button
the swivel arm into operating position 4
h
(see chapter "Operating positions").
• Remove the accessories from the drive motor
the final distance to
h
to the desired level.
g
when it is in use.
y
g to P and hold it firmly
comes to a standstill
j
f down and raise
down and bring
f
to P and hold it firmly
g
j comes to a standstill
down and raise
f
down and bring
f
• Remove the mixing bowl
• Clean all parts (see chapter "Cleaning and care").
Working with the food
processor
Note: Ensure that on the swivel arm
the kneading hooks
j mixing beater
Proceed as follows to prepare the appliance for
operation with the food processor
• Press the unlocking button
the swivel arm
(see chapter "Operating positions") (Fig
• Insert the mixing bowl
bowl must engage in the recesses
y
appliance.
. • Press the unlocking button
g
the swivel arm
(see chapter "Operating positions").
• Remove the drive protection lid for the food
processor
• Insert the food processor
(The "dot" marking on the food processor
the "arrow" marking on the swivel arm
then turn it clockwise as far as it will go (The "lock"
marking on the food processor
"arrow" marking on the swivel arm
• Insert the drive shaft
• Depending on the task to be performed, place
. the cutting
g
onto the drive shaft
• Place the lid with stodger
cessor u
• Set the rotary switch
Note: Do not press too many ingredients in the
food processor
chapter „Recommended filling quantities".
j . • Insert ingredients through the loading shaft with
the stodger
- 5 -
.
y
, the whisk
q
w are attached.
u
down and bring
f
into operating position 4
h
y . The base of the mixing
down and bring
f
h into operating position 1
u (Fig. ).
into the drive opening
u
u
.
a
, rasping or rubbing
s o
of the food processor
a
d onto the food pro-
and latch it down.
to the desired level.
g
u . Take note of the table in the
d .
neither
h
nor the
e
:
).
on the
k
to
u
) and
h
onto the
).
h
disc
i
.
u