Group H Screen 2 - Hyundai N5000 Instruction Manual

N5000 INSTRUCTION MAN N5000 INSTRUCTION MAN N5000 INSTRUCTION MAN N5000 INSTRUCTION MANUAL

4.3.22 Group H Screen 2

'Group H Screen 2' screen panel comes out when UP (
H Screen 1' screen panel is touched. P gain and I gain of current/speed for vector control and
vectorless control are set in this screen panel. And rated capacity, rated current, rated voltage, and
no-load current of the motor are set in this screen panel, too.
When touching any button in the sreen panel, 10KEY screen comes out for inputting values. (Refer
to [Input way of 10KEY screen]).
(1) Current P gain: set P gain of the current controller for vector control or sensorless vector control.
(2) Current I gain: set I gain of the current controller for vector control or sensorless vector control.
(3) Speed P gain: set P gain of the speed controller for vector control or sensorless vector control.
(4) Speed I gain: set I gain of the speed controller for vector control or sensorless vector control.
(5) Rated motor capacity: set the rated motor capacity in [MVA] unit.
(6) Rated motor current: set the rated motor current in [A] unit.
(7) Rated motor voltage: set the rated motor input line voltage in [kV] unit.
(8) No-load motor current: set the no-load motor current in [A] unit.
UAL UAL UAL
Figure 29 Group H screen 2
64
Chapter4 4 4 4 . . . . Inverter Operation Chapter Inverter Operation
Chapter Chapter Inverter Operation Inverter Operation
) button or DOWN button ( ) in 'Group