Operation; I Turning Power On; I Channel Selection - Icom IC-F510 Instruction Manual

I Turning power ON

q Push [ ] to turn the power ON.
• A power-up alert tone sounds for about 1 sec. and an opening
message may appear.
w If the transceiver is programmed for a start up passcode,
input digit codes as directed by your Dealer.
• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block as identical.
Therefore "01234" and "56789" are the same.
KEY [P0] [P1]
0 1
NUMBER
5 6
e When the "
" indication does not clear after in-
putting 4 digits, the input code number may be incorrect.
Turn power off and start over in this case.
[P2] [P3] [P4]
2 3 4
7 8 9

OPERATION

I Channel selection

Several types of channel selections are available. Methods
may differ according to your system set up.
NON-BANK TYPE:
Push [CH UP]/[CH DN] to select the desired operating chan-
nel, in sequence; or, push one of the [CH 1] to [CH 4] to select
a channel directly.
BANK-TYPE:
Push [BANK] to select the desired bank number.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
the power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call or when taking the mi-
crophone off hook.
2
8