Smartrunk Ii™ Operation; I Smartrunk Ii™ And Conventional Modes; I Smartrunk Ii™ Operation - Icom IC-F510 Instruction Manual

4
SmarTrunk II™ OPERATION
I SmarTrunk II™ and
conventional modes
This transceiver is capable of SmarTrunk II™ functions.
The optional UT-105 allows communication in conventional
channels or SmarTrunk II™ channels. Select a channel bank
for SmarTrunk II™ before trunking operation.
• Push [BANK] several times to select a channel bank for con-
ventional channels or SmarTrunk II™ channels.
- Scanning starts when a channel bank for SmarTrunk II™ opera-
tion is selected.
- Contact your Dealer for channel bank details.
NOTE: The optional DTMF microphone is required. Con-
tact your Dealer for details.
23
I SmarTrunk II™ operation
These features are enabled by a Dealer and may not be
available in your system. Contact your Dealer for details.
D D Placing a telephone call
Enter the phone number followed by [1], [✱].
• A high-pitched beep indicates that the number is accepted.
• When the called party answers, push the [PTT] switch to talk, and
release it to listen.
D D Calling another local system subscriber
Enter the subscriber number followed by [3], [✱].
• A high-pitched beep indicates that the number is accepted.
• You hear ringing, then two short beeps when the subscriber an-
swers.
• If the other subscriber is on another call or out of range, you hear a
fast busy signal and the call terminates automatically.
D D Receiving a call
When you hear ringing, push [✱] to answer.
• For a group call, you hear a short ring followed by two short beeps.
You do not have to answer a group call to hear it over the air.