D Direct Code Entry - Icom IC-F510 Instruction Manual

D D Direct code entry
qDuring standby condition, push [TX CODE ENT] to select
call code entering condition.
Queue memory content is displayed.
wSelect the desired code number via [
[TX CODE ENT].
• Programmable digit number differs according to the setting.
• When the optional DTMF microphone is used, push the appro-
priate digit key, [0] to [9], to set the desired code.
e Repeat step w until the desired code is set.
• After the code is entered, the digit stops blinking.
r Push [CALL (P0)] or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and " " is displayed during each call. However, an
error beep sounds and "
answer back is received after the calls.
t Push [PTT] to transmit; release to receive.
y Push [MONI (P4)] to clear down.
For your information
When the "UpDate" setting for the call code is enabled, the
set code is overwritten into the call code memory.
]/[ ] then push
" is displayed when no
3
BIIS OPERATION
14