I Transmitting A Call; D Calling Back From The Queue Channel - Icom IC-F510 Instruction Manual

3
BIIS OPERATION

I Transmitting a call

A total of 3 ways for code selection are available— selecting
the call code from memory, entering the call code from the
keypad and calling back from the queue channel record.
D D Using call memory
qDuring standby condition, push [DIGITAL (P1)] to select
call code memory channel.
• " " appears.
w Push [
]/[ ] to select the desired call code.
e Push [CALL (P0)] or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and " " is displayed during each call. However, an
error beep sounds and "
answer back is received after the calls.
r Push [PTT] to transmit; release to receive.
t Push [MONI (P4)] to clear down.
13
Appears
" is displayed when no
D D Calling back from the queue channel
qDuring standby condition, push [DIGITAL (P1)] for 1 sec. to
select queue memory.
w Push [
]/[ ] to select the desired record.
Queue memory content is displayed.
e Push [CALL (P0)] or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and " " is displayed during each call. However, an
error beep sounds and "
answer back is received after the calls.
r Push [PTT] to transmit; release to receive.
t Push [MONI (P4)] to clear down.
" is displayed when no