GMC 1982 Light Duty Truck Service Manual page 385

STABILIZER SHAFTS
Refer to Fig. 3D-9, 3D-10 and 3 D -1 1 for specific rear
stabilizer shaft mounting on C and P models.
Replacement
1. Raise vehicle on hoist and support rear axle.
2. Remove nut, washer and grommet from link bolt at the
frame side member on each side.
3. Withdraw link bolt, washers, grommets and spacer.
Fig. 3D-7~Shock Absorber-P-10, 20
Fig. 3D-8--Shock Absorber-P30
4. Remove brackets from anchor plates by removing
attaching screws.
5. Remove stabilizer shafts.
6. Reverse above steps to install stabilizer shaft. On
installation, position shaft so parking brake cable is
routed over stabilizer.
7. Torque all bolts to specifications.
NOTICE: See N O T I C E on page 1 of this section,
regarding stablizer fasteners.
8. Lower hoist and remove vehicle.
Fig. 3D-9--Rear Stabilizer Shaft-C-20(03)
REAR SUSPENSION 3D -3