GMC 1982 Light Duty Truck Service Manual page 178

2D-16 BODY
5. Remove door lock lever from rubber m ount at top of
motor actu ato r and remove m otor through access hole.
6. To install, reverse steps 1 through 5 above.
DOOR TO BO DY O P E N IN G W EATHERSTRIP--FIG.
2 D -4 0 , 2D -41
Side door sealing incorporates an inner seal Fig. 2D-40
and a secondary seal Fig. 2D -41. The inner seal is mounted
on the body opening welding flange and goes completely
around the periphery of the opening. The secondary seal is
adhered to the upper portion of the door by adhesive and a
screw at either end of the seal. The molded w eatherstrip
m aterial of the inner seal is snapped in place. A fter
removing all foreign m aterial from door opening surface
proceed as follows:
1. Open door and block open.
2. Remove sill p late re ta in in g screws and rem ove sill
plate.
3. Remove side door inner w eatherstrip seal.
4. S tartin g at the bottom center of the door opening,
install seal on welded flange.
5. Trim inner w eatherstrip with a notch and butt ends
together.
6. Reinstall sill plate and sill plate retaining screws.
REAR SIDE DO O R-CREW CAB A N D SUBURBAN
MODELS
A djustm ents an d H inge R eplacem ent
The procedures for hinge replacem ent, and for hinge
and striker bolt adjustm ent are sim ilar to those detailed in
the front door adjustm ent procedure. Access to the hinges of
the rear door is shown in figure 2D-42.
S TA TIO N A R Y G LA SS-REAR DOOR
R eplacem ent
1. Lower window to full down position.
2. Remove remote control knob and window regulator
handle.