GMC 1982 Light Duty Truck Service Manual page 221

2. Remove brackets from seat.
Installation
1. Install brackets to seat. Torquc to specifications.
2. Install seat to seat riser. Torque to specifications.
SEAT RISER
Rem oval
1. Remove seat and mounting bracket as an assembly.
2. Remove riser from floor.
Installation
1. Install riser to floor. Torque nuts to specifications.
2. Install seat riser. Torque nuts to specifications.
REAR BENCH SEATS
All models equipped with 2nd, 3rd and 4th bench seat
assemblies feature a quick release mechanism which
facilitates removal of the seats for added cargo space.
Instead of the conventional clamp and bolt method of
seat retention, cam type latch assemblies and hooked
retainers, which fit onto anchor pins in floor anchor plates
are used. When the latch assemblies are depressed, their
cams and the hooks of the retainers are drawn tightly onto
the anchor pins for secure seat attachment.
Removal is accomplished
procedure:
1. Pull up on quick release latches located at lower front
of seat legs (right and left hand sides).
2. Tilt up front of seat and push seat rearward to clear
anchor pins located beneath floor at front and rear of
seat legs.
3. Lift seat up and remove from van.
4. To replace, reverse steps 1 to 3.
NOTICE: When replacing seats make sure that seat
retainer hooks are fully engaged with anchor pins and
latching assembly is fully depressed into place.
SW IVEL BUCKET SEATS - G MODELS
Refer to the illustration in Figure 2D-137 for swivel
Bucket Seat Assembly installation.
ROOF VENT - G MODELS
Roof vent installation is illustrated in Figure 2D -138.
SERVICIN G LAP BELTS
Service precautionary items are outlined in the CK
portion of this section.
Internal drive thread-form ing anchor bolts are used to
secure lap belts to the floor pan. To remove or install internal
drive anchor bolts, use door lock striker and lap belt anchor
bolt removal tool J -2 3 4 5 7 or equivalent. Start bolt by hand to
assure that bolt is threaded straight.
Refer to figures 2D-139 through 2D-141 and select the
a pp ro priate illustration for removing and installing lap
belts.
DECAL APPLIQUE PROCEDURE
Refer to Section 2C, Chassis Sheet M etal, for
procedure relating installation of decals or stripes.
ADHESIVE BODY SIDE MOLDING
Refer to Section 2C, Chassis Sheet M etal, for
procedures relating to installation of adhesive moldings.
BODY 2D-59
using the following