GMC 1982 Light Duty Truck Service Manual page 179

Fig. 2D -42--R ear Door Hinge Location
3. Remove screws retaining door trim pad, and remove
trim pad. See figure 2D-43.
4. R em ove glass run chan n el by rem oving screws
retaining channel to door. See figure 2D-44.
5. Remove stationary glass.
6. R eplace glass by reversing above procedure.
Glass Run Channel A djustm ent
Figure 2D-45 illustrates the front run channel. At the
lower end, a slotted b ra c k e t provides for in-and -ou t
NOTE: ROTATE TO
INSTALL INTO TR IM
PANEL SLOT.
Fig. 2D-43--Side Rear Door Trim Pad
Fig. 2D-44--G lass Run Channel
adjustm ent. The screw and locknut at th at bracket allow
fo re-an d -aft a d ju stm en t. T ogether, this allow s proper
alignm ent of the glass to the rear glass run channel for full
up and down travel.
W IN D O W G L A S S -F IG . 2 D -4 6
R eplacem ent
1. Lower glass to full down position.
2. Rem ove rem ote control push botton knob, window
regulator handle and trim pad.
3. Rem ove sta tio n a ry glass as previously outlined.
Remove screws from rear division channel, and slide
channel rearw ard in the opening.
4. Raise glass as far as possible, then slide glass until the
roller is in line with the notch in the sash channel. See
figure 2D-46. D isengage roller from channel.
Fig. 2D-45--Glass Run Channel Adjustment
BODY 2D-17