GMC 1982 Light Duty Truck Service Manual page 219

REAR DOOR UPPER OR LOWER LATCHES AN D/
OR LATCH RODS
Rem oval
1. Remove trim panel.
2. Disengage rod from remote control assembly. See
figure 2D-131.
3. Remove latch retaining screws and withdraw latch and
control rod.
4. Remove spring clip retaining rod to latch.
Installation
1. Install latch rod to latch.
When reinstalling the lower latch rod to control, the
short straight section attaches to the latch.
2. Install latch and rod assembly into door and connect
rod to remote control. Lube all moving parts.
3. Install latch retaining
specifications.
4. Adjust latch to strikers.
REAR DOOR OUTSIDE HANDLE
„ Rem oval
1. Remove trim panel.
2. Remove door handle retaining screws, handle and
gaskets. See figure 2D -132.
Installation
1. Apply grease to remote control where handle plunger
makes contact.
2. Install handle and
specifications.
3. Install trim panel.
,'
*
screws and torque
gaskets. T orque screws
Fig. 2D-132--Outside Handle and Lock Cylinder
REAR DOOR LOCK CYLINDER
Rem oval
1. Remove trim panel.
2. Remove remote control.
3. Remove lock cylinder retainer and lock cylinder.
Installation
1. Install lock cylinder and retainer.
2. Install remote control. Torque screws to specifications.
3. Install trim panel.
REAR DOOR GLASS AND WEATHERSTRIP
Removal and installation procedures are the same as
for the statio nary body side windows. Refer to those
procedures for rear
to
replacement.
REAR DOOR ADJUSTMENTS
Door adjustments are provided by slotted holes, at
hinge attachment, in body and door.
1. Remove or loosen door strikers and wedges.
2. Loosen door hinge bolts and adjust door to provide
equal clearances between body and door around
perimeter of door.
3. Adjust door in and out so that door panel is flush with
body.
to
4. Install door strikers and wedges and adjust as outlined
under door striker adjustment.
BODY
door glass and w eatherstrip
2D-57