GMC 1982 Light Duty Truck Service Manual page 210

2D-48 BODY
Fig. 2 D -1 18--Lock and Remote Control Assembly
Fig. 2D-117--Power W indow and Power Door Lock Wiring
11. Remove screw locking sector gear in a fixed position.
12. Install regulator in reverse order of removal, lubricate
regulator gears and
equivalent.
DOOR LOCK-FIGURE 2D-118
Rem oval
1. Raise window.
2. Remove inside handles with Tool J-9886-01.
3. Remove trim panel.
4. Remove door lock knob.
5. From outside the door remove screws retaining lock to
door edge and lower the lock assembly.
6. Remove screws retaining remote control.
7. Remove screws securing glass run guide channel.
8. Remove lock, push button rod and remote control rod
as an assembly.
Installation
1. Transfer remote rod with clip to new lock.
2. Connect remote door handle rod to lock after lock is
positioned.
3. Secure lock screws and glass run guide channel.
4. Secure remote handle.
5. Check all controls for proper operation
reinstalling trim and handles.
, , ,
6. Install door lock knob.
rollers with lubriplate
before
or