GMC 1982 Light Duty Truck Service Manual page 180

2D-18 BODY
Fig. 2D-46--Window Glass and Regulator Assembly
5. Tilt window outboard and move until other roller can
be removed from channel.
6. Raise window up and out.
7. Reverse above procedure for installation.
W IN D O W REGULATOR A S S E M B L Y -F IG . 2 D -4 6
R eplacem ent
1. Remove trim pad, stationary glass, and window glass as
outlined earlier.
2. Remove screws attachin g regulator assem bly to door
inner panel.
3. Remove regulator assem bly through opening in door.
4. Install reg u lato r by reversing above procedure.
L ubricate regulator gear with lubriplate or equivalent.
Fig. 2D-47--Lock Assembly and Inside Handle
LOCKS HANDLES A N D RODS
Lock Assem bly—Fig. 2 D -4 7
R eplacem ent
1. Remove window regulator handle, remote control push
2. Disengage three clips which retain control rods to lock
3. Remove screws retaining lock assem bly to door panel,
4. Install lock by reversing above procedure. Be sure to
Inside H a n d le —Fig. 2 D -4 7
R eplacem ent
1. Remove regulator handle, rem ote control knob and
2. Disconnect control rod from inside handle by removing
3. Remove inside handle by removing four screws which
4. Replace handle by reversing above procedure.
Rem ote Control—Fig. 2 D -4 8
R eplacem ent
1. Remove regulator handle, rem ote control knob and
2. Disconnect remote control lower rod from door lock
3. Remove two screws securing each rem ote control lever
4. Remove rem ote control levers and rods through door
5. Replace by reversing above procedure.
W ITH POW ER
LOCKS
button knob and trim pad as outlined previously.
assembly.
a. Inside handle control rod.
b. Rem ote control lower rod.
c. O utside handle control rod.
then remove lock assembly.
replace all clips removed with new clips on installation.
trim pad as outlined previously.
clip as shown in figure 2D-47.
secure handle to door panel.
trim pad.
assembly.
to door panel.
opening.
R EM O TE
C O N T R O L
A SS E M B LIE S
Fig. 2D-48-Remote Control Assembly