GMC 1982 Light Duty Truck Service Manual page 174

2D-12 BODY
Fig. 2D-25--Door Trim Panel
R E T A IN IN G S P R IN G
(D IS E N G A G E D )
T O O L J -9886-01
Fig. 2D -26-C lip Retained Inside Handle Removal
DO OR VENTILA TO R A S S E M B LY -Fig. 2 D -2 8
Rem oval
T he channel betw een the d o o r w indow glass and door
vent is rem oved as part o f the vent assembly.
N O TE : R O TA TE T O
IN S TA LL IN T O T R IM
P A N E L S LO T.
Fig. 2D-27--Door Trim Pad
1. R e g u la te th e d o o r w in d o w glass to th e fu ll d o w n
position.
2. Remove clip from the window regulator handle, and
knob from lock rod.
PU S H T O O L IN
3. Remove arm rest screws and trim panel. See figure 2D-
27.
4. Remove screws attaching ventilator lower assembly to
door panel.
5. Remove three screws at the upper front of the door
frame.
6. Pull upper portion of vent assem bly rearw ard and raise
upward while rotating counter clockwise.
7. T urn vent assem bly 90° and carefu lly rem ove by
guiding up and out. See figure 2D-29.
V e n tilato r Glass R eplacem ent
1. Using an oil can or sim ilar m eans, squirt prepsol or
equivalent on the glass filler all around the glass
channel or fram e to soften the old seal. W hen
Fig. 2D-28--Door Ventilator Assembly
Fig. 2D-29--Removing Ventilator Assembly