GMC 1982 Light Duty Truck Service Manual page 220

2D-58 BODY
REAR DOOR STRIKER AND W EDGE ADJUSTMENT
NO TIC E: See N O T I C E on page 1 of this section
regaring Rear Door Striker fasteners.
1. Adjust striker by adding or deleting shims as necessary
to obtain dimension as shown in figure 2D-133. This
dimension can be checked by applying grease to the
latch and slowly closing door until striker fully engages
latch. Then open door and measure from grease
impression to bottom
specifications.
2. Adjust door wedge by adding or deleting shims as
necessary so that wedge contact ramp on body when
door is closed. See figure 2D-133.
N O TIC E : See N O T I C E on page 1 of this section
regarding fasteners used on seats and seat belts.
of latch slot. Torque to
SEATS
Fig.
2D-133--Rear Door Striker
DRIVERS SEAT
Seat Adjuster
R eplacem ent
1. Remove seat by removing nuts securing seat adjuster to
seat riser.
2. Remove adjuster from seat. See figure 2D-134.
3. Install seat adjuster
specifications.
4. Install seat onto seat riser, and torque nuts to
specifications.
SEAT RISER
R eplacem ent
1. Remove seat and adjusters as an assembly by removing
nuts securing seat to riser.
2. Remove nuts securing seat riser to floor.
3. Install seat riser to floor. Torque nuts to specifications.
4. Install seat and torque nuts to specifications.
PASSENGER SEA T-M O U N TIN G BRACKETS
Rem oval
1. Remove seat and brackets from seat riser. See figure
2D-135.
and Wedge Adjustment
to seat. T orque bolts to