GMC 1982 Light Duty Truck Service Manual page 148

2B-2 BUMPERS
Fig. 2B-3--Rear Bumper -
right bum per bracket.
3. Remove bum per from vehicle.
4. If necessary, remove the rear stone shields and the
bum per brackets and braces from fram e by removing
bolt attachm ents.
Installation
Install rear bum per following removal procedure in
reverse order. Connect license lam p wiring on suburban,
panel, and pickup models.
REAR STEP BUMPER C A N D K MODELS
R em oval (Fig. 2B-4)
1. Disconnect license lam p wiring.
2. Remove bolts connecting bum per to braces.
3. Remove bolts retaining bum per to brackets.
4. Remove bum per assembly.
5. Remove bolts securing bum per brace to fram e and
bum per b rack ets and rein fo rcem en ts to fram e if
necessary.
Fig. 2B-4--Rear Step Bumper
C -K R E A R B U M P E R
C, K Models
.1 6 0 /.1 8 0 Ref
(CLEAR ANC E)
C and K Models
Fig. 2B-5--Front Bumper - G Models
Installation
Install re ar step bum per by reversing rem oval
procedure. Connect license lam p wiring.
FRONT BUMPER - G MODELS
R em oval Fig. 2B -5, 2B -6
1. Remove nuts securing bum pers to brackets and braces
from left and right side. Remove bum per.
2. If necessary to remove the braces and brackets, remove
screws securing brackets and braces to sheet metal.
3. If equipped with bum per guards (Fig. 2B-6) they may
be removed from the face b ar at this time.
Installation
Reverse removal steps to install bum pers.
Fig. 2B-6--G-Models Front Bumper Guards