GMC 1982 Light Duty Truck Service Manual page 187

Fig. 2D-68--Latches and Rods
Fig. 2D-69-Removing Side Latch
INSIDE HANDLE
CONTROL ROD
Fig. 2D-70--Control Assembly and Blockout Rod
Fig. 2D-71--Removing Control Assembly and Inside Handle
15. Remove outside handle by removing nuts from inside
16. Reverse the above steps for reassembly.
ELECTRIC WINDOW-UTILITY MODELS
the regulator, drive cable and a 12V DC reversible motor
m ounted to the endgate inner panel. This circuit also
includes a block out switch to prevent operation of the
window while the endgate is open (fig. 2D-75).
same as outlined above with the following exceptions:
Drive Cable
cable from the motor and jackscrew assembly and removing
the cable. Reverse removal procedure to reinstall cable.
BLOCKOUT
ROD
BRACKET
CONTROL
ASSEMBLY
of outer panel. See figure 2 D -6 1.
The window is controlled by a jackscrew mounted to
Service procedures for endgate disassembly are the
The drive cable can be replaced by disengaging the
Fig. 2D-72--Window and Regulator
BODY 2D-25