GMC 1982 Light Duty Truck Service Manual page 168

2D-6 BODY
INSIDE REAR V IE W M IRRO R - FIGURE 2 D -1 1
R eplacem ent
1. Remove screw retaining m irror to its glass-m ounted
bracket and remove m irror.
2. Install m irror into its m ounting bracket. Torque screw
to specifications.
CO W L V E N T V A LV E - FIGURE 2 D -1 2
Two styles are shown in Figure 2D-12. Removing the
attaching screws allows removal of the valve from the side
panels.
BODY GLASS
C A U TIO N : A lw ays w e a r gloves a n d eye glasses
w h e n h and ling glass to avoid personal injury.
CK TRUCK W IN DSHIELD REPLACEMENT
The windshield is a one-piece type and is retained in the
w indshield
w eatherstrip. See figure 2D-13.
W hen replacing a cracked windshield glass, it is very
im p o rtan t th a t the cause of the glass break ag e be
determ ined and the condition corrected before a new glass is
installed. O therw ise, it is highly possible th a t a sm all
obstruction or high spot somewhere around the windshield
opening will continue to crack or break the newly installed
windshield especially when the strain on the glass caused by
this obstruction is increased by such conditions as wind
pressures, extrem es of tem perature, motion of the vehicle,
etc.
To replace a window installed with urethane adhesive
requires replacem ent of the adhesive m aterial. Adhesive
service kits No. 1052420 and No. 9631000 contain some of
the m aterials needed to remove and replace a urethane
adhesive installed glass. These kits and other m aterials that
may be required can be obtained through the service parts
system. The components of glass adhesive kits (urethane)
No. 1052420 and 9631000 are as follows:
opening by a u re th an e bonded rubber