Table of Contents
Advertisement
Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild
12/10/12
The thermistor of the heated print bed gets plugged into the electronics as shown above. The
heating cables are connected to the upper screw terminal of the electronic like it is shown
with the red cable in the picture above. For both cables the colour coding is not relevant.
Adding the heat sinks
Take the 4 heat sinks and apply a bit of heat thermal glue to the bottom of them. Then place
each heat sink onto one stepper drive and make sure to leave the potentiometers accessible.
Connection of the power supply to the electronic
Page 52/ 53
Advertisement
Table of Contents
