Step 1.5 - 2Print Beta Beta Prusa V2 Deluxe EasyBuild Assembly Instructions Manual

Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild 12/10/12

Step 1.5

Needed parts for step 1.5
The following parts are needed for this step:
2x Bar clamps
4x Washer M8
4x Nut M8
1x Threaded rod M8 x 440 mm
and the structure from the previous step
Assembly Step 1.5
Push the threaded rod through the two bar clamps at the bottom of the frame and attach the
bar clamps on both sides with washers and nuts as shown in the picture above.
Assembly detail
Page 12/ 53