Step 2.2 - 2Print Beta Beta Prusa V2 Deluxe EasyBuild Assembly Instructions Manual

Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild 12/10/12

Step 2.2

Needed parts for step 2.2
The following parts are needed for this step:
1x Belt
and the structure from the previous step
Assembly of the belt
Secure the belt on the thin belt clamp and loop the belt around the belt guide, around the gear on the
other side and over the other belt guide back to the carriage, as shown in the picture above.
Assembly of the belt
Page 16/ 53